DC Module : Direct Current Management
/in Product EC/by claraDC Module : Direct Current
DC module for low-voltage installations.
The DC module “Direct current” , is a complementary module to elec calc™. It meets the sizing needs of auxiliary networks (control command) and general distribution, excluding those covered by specific standards or regulations (photovoltaic, rail traction, etc.).
With the DC module, take advantage of all the features of the elec calc™ software (manufacturers’ catalogs, drawing, layout, editions, exports, etc.) and develop the DC and AC parts of your electrical installation in a single project.
Application fields
- The DC calculation module is intended to low voltage installations up to 1.500V that do not fall under any specific standard
- It meets the needs of sizing auxiliary networks (Instrumentation and Control), socket and/or lighting distribution, …
OUR PRESENTATION VIDEO
Reference documents
In the case of low-voltage networks, the applicable electrical installation standards are identical to those for AC networks, in particular those in the IEC 60364 series or their national versions. For the calculation of short-circuit currents, reference should be made to the IEC 61660 series of standards.
Managed components
Sources
The following DC sources are managed for a 2-wire supply with a TNC, TNS or IT earth connection diagram.
- Rectifier only
- Battery only
- Rectifier / battery unit
Receivers
- Plugs
- Lighting
- Resistive loads
- Generic receivers
Switching devices
- Contactor
- Switch
Protections
- Circuit breaker
- Fuse
Other
- Distributor
- Wiring system
Calculation
The following calculations are carried out in the same way as for AC installations, in accordance with the above-mentioned reference documents:
- Operating currents and power balance
- Cable sizing
- Short-circuit current calculation
- Sizing of overload protection
- Voltage drop calculation
- Thermal stress calculation
- Standard reference: IEC 61660
elec calc™ carries out all the checks required to ensure compliance with the reference documents and, where necessary, reports any alert or non-compliance points detected.
Choice of switching and protection equipment
elec calc™ provides users with specific manufacturer catalogues for switching and protection devices used in DC. Users can also manage their own catalogues as for other components.